Figure 71. Removing the LOM riser card
5. Lift the LOM riser card out of the system.
6. Remove the LOM bracket.
a) Using the Phillips #2 screwdriver, remove the screw that secures the bracket to the chassis.
b) Slide the bracket out of the slot on the chassis.
Figure 72. Removing the LOM riser bracket
7. If the LOM riser is not being replaced immediately, install the LOM filler bracket.
a) Insert and slide the filler into the slot on the chassis.
b) Using the Phillips #2 screwdriver, secure the filler bracket to the chassis with a screw.
86
Installing and removing system components
To Next Page
Loading...
