Figure 73. Installing the LOM filler bracket
Next steps
Replace the LOM riser card.
Installing the LOM riser card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. If installed, remove the risers.
Steps
1. Remove the LOM filler bracket.
a) Using the Phillips #2 screwdriver, remove the screw that secures the bracket to the system.
b) Slide the bracket out of the slot on the system.
Figure 74. Removing the LOM filler bracket
Installing and removing system components
87
To Next Page
Loading...
