Figure 42. Removing NVDIMM-N battery from mid drive tray
Next step
Install NVDIMM-N battery into mid drive tray.
Installing NVDIMM-N battery into mid drive tray
Prerequisites
Follow the safety guidelines listed in Safety instructions.
CAUTION
: NVDIMM-N battery is not hot swappable. To prevent data loss and potential damage to your system, ensure that your
system, LEDs on system, LEDs on NVDIMM-N and LEDs on NVDIMM-N battery are turned o before installing the NVDIMM-N
battery.
CAUTION: To avoid damage to the battery connector, you must rmly support the connector while installing or removing a
battery.
Steps
1 Connect the cables to the NVDIMM-N battery.
2 Slide the NVDIMM-N battery to engage the battery with the drive tray.
3 Using Phillips #2 screwdriver, tighten the screw to secure the NVDIMM-N battery.
4 Lower the drive tray handle.
Installing and removing system components
89
To Next Page
Loading...
