Figure 53. Installing a 3.5 inch adapter into a 3.5 inch drive carrier
Next steps
1 Install a 3.5 inch drive carrier into the system.
2 Follow the procedure listed in After working inside your system.
Removing the drive from the drive carrier
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the safety guidelines listed in Before working inside your system.
CAUTION
: Mixing drives from previous generations of PowerEdge servers is not supported.
Steps
1 Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2 Lift the drive out of the drive carrier.
Installing and removing system components
99
To Next Page
Loading...
