5 Place the heat sink on the processor and push down on the base of the heat sink until the bracket locks onto the heat sink.
NOTE:
• Ensure that the two guide pin holes on the bracket match the guide holes on the heat sink.
• Do not press on the heat sink ns.
• Ensure that the pin 1 indicator on the heat sink is aligned with the pin 1 indicator on the bracket before placing the heat
sink onto the processor bracket.
Figure 80. Installing the heat sink onto the processor
Next steps
1 Install the processor and heatsink.
2 If removed, install the risers.
3 If removed, install the rear drive cage.
4 Install the air shroud.
5 Install the system cover.
6 Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
7 Open the drive bays, install all drives, and then close the drive bays.
8 Install the power supply units.
9 Follow the procedure listed in After working inside your system.
108
Installing and removing system components
To Next Page
Loading...
