Dell EMC PowerEdge R740xd2 - Installing Expansion Card on the System Board

Figure 95. Installing expansion card into buttery riser
Next steps
1 Install the expansion card riser in the system.
2 If applicable, connect the cables to the expansion card.
3 If removed, install the rear drive cage.
4 Install air shroud.
5 Install the system cover.
6 Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
7 Open the drive bays, install all drives, and then close the drive bays.
8 Install the power supply units.
9 Follow the procedure listed in After working inside your system.
10 Install any device drivers required for the card as described in the documentation for the card.
Installing expansion card on the system board
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet, and disconnect the peripherals.
4 Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5 Open the drive bays, remove all drives, and then close the drive bays.
6 Remove the power supply units.
7 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
Installing and removing system components
123