Dell EMC PowerEdge R740xd2 - Optional IDSDM; Vflash Module

8 Remove the system cover.
9 Remove the air shroud.
10 Remove the BOSS card.
NOTE: The procedure to remove the BOSS card is similar to the removing an expansion card.
Steps
1 Insert the M.2 SSD module at an angle into the BOSS card connector.
2 Push the other end of the M.2 SSD module until it rests on the stand o on the BOSS card.
3 Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS card with the screw.
Figure 107. Installing the M.2 SSD module
Next steps
1 Install the BOSS card.
NOTE
: The procedure to install the BOSS card is similar to the installing an expansion card on the system board.
2 Install the air shroud.
3 Install the system cover.
4 Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
5 Open the drive bays, install all drives, and then close the drive bays.
6 Install the power supply units.
7 Follow the procedure listed in After working inside your system.
Optional IDSDM / vFlash module
The write-protect switch is on the IDSDM module.
Installing and removing system components
133