Installing the LOM riser card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet, and disconnect the peripherals.
4 Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5 Open the drive bays, remove all drives, and then close the drive bays.
6 Remove the power supply units.
7 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
8 Remove the system cover.
9 Remove the air shroud.
10 If installed, remove the rear drive cage.
11 If installed, remove the risers.
Steps
1 Align the connectors on the LOM riser card with the slot on the system.
2 Press the LOM riser card until the card is rmly seated on the system board connector and the two blue plastic clips hold the LOM
riser card in place.
3 Using a Phillips #2 screwdriver, replace the screws to secure the LOM riser card to the system board.
Figure 113. Installing LOM riser card
Next steps
1 If removed, install the risers.
2 If removed, install the rear drive cage.
Installing and removing system components
139
To Next Page
Loading...
