Figure 114. Removing the system battery
3 To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4 Press the battery into the connector until it snaps into place.
Figure 115. Installing the system battery
Next steps
1 If removed, install the low prole or full height X1 expansion card risers.
2 If applicable, connect the cables to the expansion card(s).
3 If removed, install the air shroud.
4 Install the system cover.
5 Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
6 Open the drive bays, install all drives, and then close the drive bays.
7 Install the power supply units.
8 Follow the procedure listed in After working inside your system.
9 While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
Installing and removing system components
141
To Next Page
Loading...
