Dell EMC PowerEdge R740xd2 - Optional Internal USB Memory Key; Replacing the Optional Internal USB Memory Key

10 Enter the correct time and date in the System Setup Time and Date elds.
11 Exit the System Setup.
Optional internal USB memory key
NOTE: To locate the internal USB port on the system board, see the System board jumpers and connectors section.
Replacing the optional internal USB memory key
Prerequisites
CAUTION: To avoid interference with other components in the server, the maximum permissible dimensions of the USB memory
key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1 Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet, and disconnect the peripherals.
4 Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5 Open the drive bays, remove all drives, and then close the drive bays.
6 Remove the power supply units.
7 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
8 Remove the system cover.
9 Remove the air shroud.
10 If installed, remove the low prole expansion card riser.
Steps
1 Locate the USB port or USB memory key on the system board.
To locate the USB port, see the jumpers and connectors.
2 If installed, remove the USB memory key from the USB port.
Figure 116. Removing the internal USB memory key
1
USB memory key 2 USB port
3 Insert the replacement USB memory key into the USB port.
142
Installing and removing system components