Figure 128. Removing the support bar, cable chain top cover and disconnecting the bay 2 backplane bracket from the cable chain
assembly.
4 Loosen the captive screw for the cable chain side cover and disengage it from the guiding pins below and lift it away from the system.
5 Slide the left side of the system, partially o the table, until the bottom screws for the cable chain base bracket are visible and remove
the screws.
CAUTION
: Make sure the system is placed on a work bench before working for this step, as tilting the system or placing
it on its side on the ground, would risk stressing the chassis or toppling the system, causing damage to components.
158 Installing and removing system components
To Next Page
Loading...
