Figure 135. Replacing the support bar, cable chain top cover and connecting the bay 2 backplane bracket from the cable chain
assembly.
Next steps
1 Replace the following:
a PIB.
b Memory modules for processor 1.
c Internal PERC card
d If installed, rear drive cage.
e Intrusion switch.
f Air shroud.
g Drive bay 1 bracket.
h Drive bay 2 bracket.
i Connect all the cables to the backplane and system board.
2 Install the system cover.
3 Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
4 Open the drive bays, install all drives, and then close the drive bays.
5 Install the power supply units.
6 If removed, install front bezel.
7 Follow the procedure listed in After working inside your system.
Installing and removing system components
165
To Next Page
Loading...
