Figure 136. Removing the left control panel
Next step
Replace the left control panel.
Installing the left control panel
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet, and disconnect the peripherals.
4 Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5 If installed, remove the front bezel.
6 Open the drive bays, remove all drives, and then close the drive bays.
7 Remove the power supply units.
8 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
9 Remove the system cover.
10 Remove the cable chain assembly.
Steps
1 Align the left control panel assembly with the control panel slot on the chassis and using Phillips #1 screwdriver, replace the screws to
secure the left control panel assembly to the chassis.
2 Route the left control panel cable through the cable channel of the system.
Installing and removing system components
167
To Next Page
Loading...
