Figure 141. Installing the right control panel
Next steps
1 Install the internal PERC card.
2 Install the air shroud.
3 Close the drive bays.
4 Install the system cover.
5 Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
6 Install the power supply units.
7 Open the drive bays, install all drives, and then close the drive bays.
8 If removed, install the front bezel.
9 Follow the procedure listed in After working inside your system.
172
Installing and removing system components
To Next Page
Loading...
