Figure 20. Installing the front bezel
System cover
Removing the system cover
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet, and disconnect the peripherals.
4 Open the drive bays, remove all drives, and then close the drive bays.
5 Remove the power supply units.
6 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
Dell.com/poweredgemanuals.
Steps
1 Using a 1/4-inch at head or Phillips #2 screwdriver, turn the lock counterclockwise to the unlock position.
2 Press the release tabs on the system cover, and slide the cover towards the rear of the system.
3 Lift the cover from the system.
48
Installing and removing system components
To Next Page
Loading...
