Figure 21. Removing the system cover
Installing the system cover
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet, and disconnect the peripherals.
4 Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5 Open the drive bays, remove all drives, and then close the drive bays.
6 Remove the power supply units.
7 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
Steps
1 Align the tabs on the system cover with the guide slots on the system.
2 Slide the cover towards the front of the system, until the system cover locks in place.
3 Using a 1/4 inch at head or Phillips #2 screwdriver, turn the lock clockwise to the lock position.
Installing and removing system components
49
To Next Page
Loading...
