Figure 22. Installing system cover
Next steps
1 Close the drive bays.
2 Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
3 Open the drive bays, install all drives, and then close the drive bays.
4 Install the power supply units.
5 Follow the procedure listed in After working inside your system.
Air shroud
Removing the air shroud
Prerequisites
CAUTION
: Never operate your system with the air shroud removed. The system may get overheated quickly, resulting in
shutdown of the system and loss of data.
1
Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Disconnect the system from the electrical outlet, and disconnect the peripherals.
4 Open the drive bays, remove all drives, and then close the drive bays.
5 Remove the power supply units.
6 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
7 Remove the system cover.
50
Installing and removing system components
To Next Page
Loading...
