Figure 46. Installing a drive into the drive carrier
Next step
Install the drive carrier.
Removing a 2.5-inch drive from a 3.5-inch drive adapter
Prerequisite
NOTE
: A 2.5-inch drive is installed in a 3.5-inch drive adapter, which is then installed in the 3.5-inch drive carrier.
Steps
1 Using a Phillips #2 screwdriver, remove the screws from the side of the 3.5-inch drive adapter.
2 Remove the 2.5-inch drive from the 3.5-inch drive adapter.
74
Installing and removing system components
To Next Page
Loading...
