Dell EMC PowerEdge R740xd2 - Drive Backplane Bracket; Removing the Drive Bay 1 Backplane Bracket

Figure 50. Installing a 3.5-inch drive adapter into the 3.5-inch drive carrier
Next steps
1 Install the 3.5-inch drive carrier into the system.
2 If removed, install the front bezel.
Drive backplane bracket
Removing the drive bay 1 backplane bracket
Prerequisites
NOTE
: Ensure that the drive bay 1 and 2 is in open position to access the backplane bracket.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If installed, remove the front bezel.
4 Remove all the drives from drive bay 1.
5 Open the drive bays.
Steps
1 Using a Phillips #1 screwdriver, remove the screws on top of the drive bay 1.
2 Slide the bracket to the right to disengage it from the slots at the bay base in drive bay 1.
3 Lift the bracket away from the system.
78
Installing and removing system components