Figure 51. Removing bay 1 backplane bracket
Next step
Replace the drive bay 1 backplane bracket.
Installing the drive bay 1 backplane bracket
Prerequisites
Follow the safety guidelines listed in Safety instructions.
1 Follow the procedure listed in Before working inside your system.
2 If installed, remove the front bezel.
3 Remove all the drives from drive bay 1.
4 Open the drive bays.
Steps
1 Align the backplane bracket with the two slots at the bay base in drive bay 1.
2 Slide the bracket to the left until it is rmly seated and locks into place.
3 Using a Phillips #1 screwdriver, tighten the screws on top of the drive bay to secure the bracket.
Installing and removing system components
79
To Next Page
Loading...
