Figure 55. Removing the bay intrusion switch
Next step
Replace the bay intrusion switch.
Installing bay intrusion switch
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If installed, remove the front bezel.
4 Open the drive bays.
5 Remove the drive bay 1 bracket.
Steps
1 Align the intrusion switch to the intrusion switch slot in drive bay 1.
2 Using a Phillips #1 screwdriver, replace the screws to secure the intrusion switch.
3 Connect the intrusion cable to the backplane of drive bay 1.
Installing and removing system components
83
To Next Page
Loading...
