4 If installed, remove the mid drive tray.
WARNING
: Allow the memory modules to cool after you power o the system. Handle the memory modules by the card edges
and avoid touching the components or metallic contacts on the memory module.
CAUTION
: To ensure proper system cooling, memory module blanks must be installed in any memory socket that is not occupied.
Remove memory module blanks only if you intend to install memory modules in those sockets.
NOTE
: You must follow the thermal restriction while using DIMM blank. For information about thermal restriction, see the
Thermal restrictions section.
Steps
1 Locate the appropriate memory module socket.
CAUTION
: Handle each memory module only by the card edges, ensuring not to touch the middle of the memory module or
metallic contacts.
2 Push the ejectors outward on both ends of the memory module socket to release the memory module from the socket.
3 Lift and remove the memory module from the system.
Figure 61. Removing a memory module
Next steps
1 Install a memory module.
2 If you are removing the memory module permanently, install a memory module blank. The procedure to install a memory module blank
is similar to that of the memory module.
NOTE: For single processor systems, install processor/DIMM blank on CPU2 socket.
Installing a memory module
Prerequisites
Follow the safety guidelines listed in Safety instructions
.
CAUTION: To ensure proper system cooling, memory module blanks must be installed in any memory socket that is not occupied.
R
emove memory module blanks only if you intend to install memory modules in those sockets.
NOTE
: You must follow the thermal restriction while using DIMM blank. For information about thermal restriction, see the
Thermal restrictions section.
Steps
1 Locate the appropriate memory module socket.
CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the memory module or
me
tallic contacts.
Installing and removing system components 105
To Next Page
Loading...
