Figure 71. Securing the processor socket cover
Next steps
1 Install the heat sink
.
2
Install the air shroud.
3 If removed, install the mid drive tray.
4 If removed, install the expansion cards.
5 Follow the procedure listed in After working inside your system.
Installing the heat sink
Prerequisite
CAUTION: Never remove the heat sink from a processor unless you intend to replace the processor or system board. The heat
sink is necessary to maintain proper thermal conditions.
Follow the safety guidelines listed in Safety instructions.
Steps
1 To install the heat sink, follow either of the options listed here, as applicable:
a If you are re-using a heat sink, remove the thermal grease from the heat sink with a clean lint free cloth.
b If you are using a new heat sink, the heat sink will have the thermal paste pre-applied to the heat sink. Remove the protective
co
ver and install the heat sink.
2 If required, use the thermal grease syringe included with your processor kit to apply the grease on the top of the processor.
116 Installing and removing system components
To Next Page
Loading...
