Dell EMC PowerEdge R7425 - Network Daughter Card; Removing the Network Daughter Card

Figure 100. Installing the optional IDSDM or vFlash module
Next steps
1 Install the MicroSD cards
.
NOTE: Re-install the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2 For systems that support rear 2.5 inch or 3.5 inch drive con
guration,
install the rear drive cage.
3 Install the expansion card in slot 6 or 8.
4 Follow the procedure listed in After working inside your system.
Network daughter card
The network daughter card (NDC) is a small, removable mezzanine card, which provides the e
xibility of selecting dierent network
connectivity options.
Removing the network daughter card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the expansion card riser 2 or remove the rear drive cage, depending on the con
guration of your system.
Steps
1 Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.
2 Hold the NDC by the edges, and lift to remove it from the connector on the system board.
3 Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
144 Installing and removing system components