Dell EMC PowerEdge R7425 - Optional Internal USB Memory Key; Replacing an Internal USB Memory Key

Figure 131. Installing the USB 3.0 module
Next steps
1 Install the internal USB memory key
.
2
Install the air shroud.
3 Install the cooling fan assembly
.
4
Install the backplane cover.
5 Follow the procedure listed in After working inside your system.
Optional internal USB memory key
An optional USB memory key can be installed in the internal USB 3.0 port.
NOTE: To locate the internal USB port on the system board, see the System board jumpers and connectors section.
For con
gurations that support USB 3.0 module, the USB 3.0 module cable connects to the internal USB port on the system board. In this
scenario, the default internal USB port is available under the backplane cover. The position of the default internal USB port may vary
depending on the conguration of your system.
Replacing an internal USB memory key
Prerequisites
CAUTION: To avoid interference with other components in the server, the maximum permissible dimensions of the USB memory
k
ey are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
168 Installing and removing system components