Dell EMC PowerEdge R7425 - Installing the Left Control Panel; Removing the Right Control Panel

Installing the left control panel
Prerequisite
Follow the safety guidelines listed in Safety instructions
.
Steps
1 Route the control panel cable through the side wall of the system.
2 Align the left control panel assembly with the control panel slot on the system and attach the control panel assembly to the system.
3 Connect the control panel cable to the system board connector and secure it using cable latch.
4 Using a Phillips #1 screwdriver, install the screws that secure the control panel and cable tube to the system.
Figure 139. Installing the left control panel
Next steps
1 Install the air shroud.
2 Install the cooling fan assembly
.
3 Follow the procedure listed in
After working inside your system.
Removing the right control panel
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. You must route the
cables pr
operly when you replace them to prevent the cables from being pinched or crimped.
3 Remove the air shroud.
4 Remove the cooling fan assembly.
178 Installing and removing system components