CAUTION
: Take care not to damage the system identication button while placing the system board into the chassis.
2 Holding the system board holder and blue release pin, lower the system board aligning the connectors into the slot, and place it in the
s
ystem until the release pin click into place.
Figure 143. Installing the system board
Next steps
1 Replace the following:
a Trusted Platform Module (TPM)
.
b
Air shroud
c Cooling fan assembly
d Rear drive cage (if applicable)
e Mid drive tray (if applicable)
f Power supply unit(s)
g Expansion card riser 1
h Expansion card riser 2
i Expansion card riser 3
j Processors
k Heat sinks
l IDSDM or vFlash module
m Internal USB memory key
(if applicable)
n
USB 3.0 module (if applicable)
o Memory modules and memory module blanks
p Network daughter card
2 Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
br
acket.
3 Follow the procedure listed in After working inside your system.
4 Ensure that you:
a Use the Easy Restore feature to restore the Service Tag. For more information, see the Restoring the Service Tag by using the
Eas
y Restore feature section.
b If the Service Tag is not backed up in the backup ash device, enter the Service Tag manually. For more information, see the
Entering the system Service Tag by using System Setup section.
182 Installing and removing system components
To Next Page
Loading...
