Dell EMC PowerEdge R7425 - Serial Connector; IDSDM or Vflash Module; Video Specifications

Serial connector
The PowerEdge R7425 system supports one serial connector on the back panel, which is a 9-pin connector, Data Terminal Equipment
(D
TE), 16550-compliant.
IDSDM or vFlash module
The PowerEdge R7425 system supports optional Internal Dual SD module (IDSDM) or vFlash module. In 14th generation of PowerEdge
serv
ers, IDSDM or vFlash module are combined into a single card module, and are available in these congurations:
• vFlash or
• vFlash and IDSDM
The IDSDM or vFlash module sits in the back of the system, in a Dell-proprietary slot. IDSDM or vFlash module supports three micro SD
car
ds (two cards for IDSDM and one card for vFlash). Micro SD cards capacity for IDSDM are 16, 32, 64 GB while for vFlash the microSD
card capacity is 16 GB.
NOTE
: There are two dip switches on the IDSDM or vFlash module for write-protection.
NOTE
: One IDSDM card slot is dedicated for redundancy.
NOTE
: It is recommended to use Dell branded MicroSD cards associated with the IDSDM or vFlash congured systems.
Video specica
tions
The PowerEdge R7425 system supports integrated Matrox G200eW3 graphics controller with 16 MB of video frame buer.
Table 21. Supported video resolution options
Resolution Refresh rate (Hz) Color depth (bits)
1024 x 768 60 8, 16, 32
1280 x 800 60 8, 16, 32
1280 x 1024 60 8, 16, 32
1360 x 768 60 8, 16, 32
1440 x 900 60 8, 16, 32
1600 x 900 60 8, 16, 32
1600 x 1200 60 8, 16, 32
1680 x 1050 60 8, 16, 32
1920 x 1080 60 8, 16, 32
1920 x 1200 60 8, 16, 32
NOTE: 1920 x 1080 and 1920 x 1200 resolutions are only supported in reduced blanking mode.
32 Technical specications