Viewing Boot Settings
To view the
Boot Settings screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE
: If your operating system begins to load before you press F2, wait for the system to nish booting, and then restart
your system and try again.
3 On the
System Setup Main Menu screen, click System BIOS.
4 On the
System BIOS screen, click Boot Settings.
Boot Settings details
The Boot Settings screen details are explained as follows:
Option Description
Boot Mode Species the Boot Mode of the system. This option is set to UEFI by default.
Boot Sequence
Retry
Enables or disables the Boot Sequence Retry feature. If this option is set to Enabled and the system fails to boot,
the system re-attempts the boot sequence after 30 seconds. This option is set to Enabled by default.
UEFI Boot Settings Enables or disables UEFI Boot options.
NOTE: This option is enabled only if the boot mode is UEFI.
Network Settings
You can use the Network Settings screen to modify UEFI PXE, iSCSI, and HTTP boot settings. The network settings option is available
only in the UEFI mode.
NOTE: For information about Linux network settings, see the
Linux
®
Network Tuning Guide for AMD EPYC
™
Processor Based
Servers
AMD tuning guide.
Viewing Network Settings
To view the
Network Settings screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to nish boo
ting, and then restart
your system and try again.
3 On the
System Setup Main Menu screen, click System BIOS.
4 On the
System BIOS screen, click Network Settings.
48 Pre-operating system management applications
To Next Page
Loading...
