Dell EMC PowerEdge R7425 - Installing a 3.5 Inch Drive into the 3.5 Inch Drive Carrier

Figure 42. Removing a 3.5 inch drive from the 3.5 inch drive carrier
Next step
Install a 3.5 inch drive into the 3.5 inch drive carrier.
Installing a 3.5 inch drive into the 3.5 inch drive carrier
Prerequisite
Follow the safety guidelines listed in Safety instructions
.
CAUTION: Mixing drives from previous generations of PowerEdge servers is not supported.
Steps
1 Align the tabs on the drive carrier with the slots on the drive.
2 Pull the edges of the carrier to t the drive.
3 Lower the drive onto the drive carrier to secure it.
86 Installing and removing system components