Dell EMC PowerEdge R7425 - Removing a Drive from the Drive Carrier

Figure 53. Installing a 3.5 inch adapter into a 3.5 inch drive carrier
Next steps
1 Install the 3.5 inch drive carrier into the system.
2 Follow the procedure listed in After working inside your system.
Removing a drive from the drive carrier
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 If installed, remove the front bezel.
3 Remove the drive carrier.
CAUTION: Mixing drives from previous generations of PowerEdge servers is not supported.
Steps
1 Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2 Lift the drive out of the drive carrier.
96 Installing and removing system components