Figure 123. Installing the power interposer board
Next steps
1. Install the air shroud.
2. Install the power supply units.
3. Follow the procedure listed in After working inside your system on page 44.
System board
Removing the system board
Prerequisites
CAUTION:
If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted to create
a recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this
system board, you must supply the recovery key when you restart your system or program before you can access the
encrypted data on your drives.
1. Follow the safety guidelines listed in the Safety instructions on page 43.
2. Follow the procedure listed in the Before working inside your system on page 44.
3. Remove the following components:
a. Air shroud
b. Expansion cards
c. Expansion card riser
d. Internal mini PERC card
e. If applicable, IDSDM module
f. If applicable, internal USB
g. Memory modules
h. Processor
i. Heat sink
Installing and removing system components
133
To Next Page
Loading...
