Network Settings
To view the Network Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS >
Network Settings.
NOTE: For information about Linux network performance settings, see the
Linux Network Tuning Guide for AMD EPYC
Processor Based Servers
at AMD.com.
NOTE: Network Settings are not supported in BIOS boot mode.
Table 22. Network Settings details
Option Description
UEFI PXE Settings Enables you to control the configuration of the UEFI PXE device.
PXE Device n (n = 1 to 4) Enables or disables the device. When enabled, a UEFI PXE boot option is
created for the device.
PXE Device n Settings(n = 1 to 4) Enables you to control the configuration of the PXE device.
UEFI HTTP Settings Enables you to control the configuration of the UEFI HTTP device.
HTTP Device n (n = 1 to 4) Enables or disables the device. When enabled, a UEFI HTTP boot option is
created for the device.
HTTP Device n Settings (n = 1 to 4) Enables you to control the configuration of the HTTP device.
UEFI iSCSI Settings Enables you to control the configuration of the iSCSI device.
Table 23. PXE Device n Settings details
Option Description
Interface Specifies NIC interface used for the PXE device.
Protocol Specifies Protocol used for PXE device. This option is set to IPv4 or IPv6. This option is set to IPv4
by default.
Vlan Enables Vlan for PXE device. This option is set to Enable or Disable. This option is set to Disable by
default.
Vlan ID Shows the Vlan ID for the PXE device
Vlan Priority Shows the Vlan Priority for the PXE device.
Table 24. HTTP Device n Settings details
Option Description
Interface Specifies NIC interface used for the HTTP device.
Protocol Specifies Protocol used for HTTP device. This option is set to IPv4 or IPv6. This option is set to IPv4
by default.
Vlan Enables Vlan for HTTP device. This option is set to Enable or Disable. This option is set to Disable by
default.
Vlan ID Shows the Vlan ID for the HTTP device
Vlan Priority Shows the Vlan Priority for the HTTP device.
DHCP Enables or disables DHCP for this HTTP device. This option is set to Enable by default.
IP Address Specifies IP address for the HTTP device.
Subnet Mask Specifies subnet mask for the HTTP device.
Gateway Specifies gateway for the HTTP device.
DNS info via DHCP Enables or disables DNS Information from DHCP. This option is set to Enable by default.
Primary DNS Specifies the primary DNS server IP address for the HTTP Device.
32 Pre-operating system management applications
To Next Page
Loading...
