Dell EMC PowerEdge R7525 - Installing the Serial COM Port

Installing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 46.
2. Follow the procedure listed in Before working inside your system on page 47.
3. Remove expansion card riser.
4. Disconnect the serial COM port cable from the connector on the rear I/O board.
Steps
1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser (Riser 3).
Figure 105. Installing the Serial COM port
2. Slide the serial COM port into the expansion card riser.
3. Connect the serial COM port cable to the serial port.
146
Installing and removing system components