Figure 106. Installing the Serial COM port
Next steps
1. Reconnect the serial COM port cable to the connector on the rear I/O board.
2. Install the expansion card riser.
3. Follow the procedure listed in After working inside your system on page 47.
Optional IDSDM module
Removing the IDSDM module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 46.
2. Follow the procedure listed in the Before working inside your system on page 47.
3. If you are replacing the IDSDM module, remove the MicroSD cards.
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards
into the corresponding slots.
Steps
Holding the blue pull tab, lift the IDSDM module out of the system.
Installing and removing system components
147
To Next Page
Loading...
