Table 4. Pins for third-party racks (continued)
Rail Pins from kit Part Number and Description Suggested Use
(Quantity: 4 per kit)
036-028-016
3.8MM Alignment Pin
(Quantity: 8 per kit)
Used in racks that have M5, #10, or
#12 threaded holes.
036-028-017
4.8MM Alignment Pin
(Quantity: 8 per kit)
Used in racks that have M6 threaded
holes.
4. Install the right rail to the rack rear channel. You can adjust the rails later, if necessary. The following figure shows the
installation details.
Refer to Installing the right rail to the front channel on page 37 while performing the tasks in this step.
Install the Disk Shelves in the Rack
35
To Next Page
Loading...
