1 Rear tag....................................................................................................................................................................... 11
2 Front tag......................................................................................................................................................................11
3 Serial number for initial password......................................................................................................................... 11
4 Adjusting the lift arm bar to just under 17 inches............................................................................................. 14
5 Reconfiguring the portable lift with the Voyager conversion kit..................................................................15
6 Sliding rail assembly - 2U systems........................................................................................................................17
7 CMA brackets............................................................................................................................................................18
8 CMA arms and separators......................................................................................................................................18
9 Remove the original CMA bracket....................................................................................................................... 19
10 Attach outer CMA bracket to the rails...............................................................................................................20
11 Attach inner CMA bracket to the rails................................................................................................................ 21
12 Installing the rear end of the rail.......................................................................................................................... 22
13 Installing the front end of the rail........................................................................................................................ 22
14 Installing screws....................................................................................................................................................... 23
15 Pull out the intermediate rail................................................................................................................................. 23
16 Attach the inner rails to the system....................................................................................................................24
17 Install system into the extended rails..................................................................................................................24
18 Slide system into the rack..................................................................................................................................... 25
19 Installing the front bezel........................................................................................................................................ 25
20 Install the first separator........................................................................................................................................26
21 Install the first arm.................................................................................................................................................. 27
22 Close the first arm................................................................................................................................................... 27
23 Install the second separator.................................................................................................................................. 28
24 Install the second arm.............................................................................................................................................28
25 Close the second arm............................................................................................................................................. 29
26 Holes for alignment pins......................................................................................................................................... 31
27 Installing the rails..................................................................................................................................................... 32
28 Sliding the shelf onto the rails.............................................................................................................................. 32
29 Securing the front of the shelf.............................................................................................................................33
30 Installing the front bezel........................................................................................................................................ 34
31 Rail installation..........................................................................................................................................................36
32 Installing the right rail to the rear channel......................................................................................................... 37
33 Installing the right rail to the front channel....................................................................................................... 37
34 Sliding the shelf chassis into the rails................................................................................................................. 39
35 Unlocking the casters............................................................................................................................................. 39
36 Locking the casters................................................................................................................................................. 40
37 Removing the straps...............................................................................................................................................40
38 Inserting and securing the shelf to the cabinet (shoulder screw configuration)......................................41
39 Removing semi-captive screws............................................................................................................................42
40 Installing ears to rack using truss head screws................................................................................................ 42
Figures
Figures 5
To Next Page
Loading...
