Introduction and Preparation
Topics:
• Document purpose
•
DD6900 system features
• Product serial number tag (PSNT)
• Required tools and supplies
• Safety considerations
• Working with a portable lift
Document purpose
This installation guide provides instructions for installing the hardware associated with PowerProtect systems. Systems are
shipped to the customer site either pre-installed in a rack (factory-racked) or as separate components to install in an existing
rack at the site (field-installed). This guide provides instructions for both types of installation.
This document is intended for customers or Dell EMC Support personnel who are qualified to install PowerProtect systems.
Field-installed systems
To install PowerProtect systems in an existing rack at the customer site, follow all the instructions in this document to rack,
cable, and configure the system.
Factory-racked systems
Factory-racked systems are pre-installed in the rack with the cables already connected. Follow the instructions in Configure
System for Use on page 74 to configure factory-racked systems.
The following documents, available from the Online Support website, provide additional information about factory-racked
systems:
● Dell EMC 40U-P Cabinet Site Preparation Guide
● Dell EMC 40U-P Cabinet Unpacking and Setup Guide
● Dell EMC Titan S Site Preparation Guide
● Dell EMC Titan S Unpacking and Setup Guide
● Dell EMC Data Domain Rack Service Guide
DD6900 system features
Table 1. DD6900 system features
Feature Single Node HA
Processor 2 x Intel Xeon 4208, 8C, 2.10GHz, 85W
Kernel 4.4
Memory Configurations Total 288 GB
DIMMs 12 x 8 GB + 12 x 16 GB
HDD Drive Size 4TB
1
Introduction and Preparation 9
To Next Page
Loading...
