2. I
nsert and tighten the two screws using the Phillips #2 screwdriver.
Figure 14. Installing screws
I
nstall the system in the cabinet
This procedure is used to install the system in the cabinet.
About this task
WARNING:
The system is heavy and should be installed in a cabinet by two people. To avoid personal injury
and/or damage to the equipment, do not attempt to install the system in a cabinet without a mechanical lift
and/or help from another person.
Steps
1
. At front of the cabinet, pull the inner slide rails out of the cabinet until they lock into place.
Figure 15. Pull the inner rails out of the cabinet
2
. Locate the rear rail standoff on each side of the system. Position the system above the rails and lower the rear rail standoffs
into the rear J-slots on the slide assemblies.
3. Rotate the system downward until all the rail standoffs are seated in the J-slots.
22 Install the System in the Rack
To Next Page
Loading...
