Dell EMC PowerProtect DD9400 - Installing the Front Bezel; Securing the Front of the Shelf; Installing the Bezel

Figure 63. Securing the front of the shelf
I
nstalling the front bezel
Prerequisites
CAUTION:
If the protective plastic strip is present on the front of the bezel, remove it before placing the system
into operation. Failure to remove the protective plastic strip will cause the system to overheat.
About this task
R
efer to Installing the bezel on page 53 while performing this procedure.
NOTE:
If the rack is equipped with a door on the front, the shelf ships with an EMI shield instead of a bezel.
Steps
1
. If present, remove the protective plastic strip from the front of the bezel.
2. Align the bezel with the enclosure.
3. Gently push the bezel into place on the cabinet until it latches.
4. If the bezel has a key lock, lock the bezel with the provided key.
CL5262
Figure 64. Installing the bezel
Install the Disk Shelves in the Rack 53