Dell EMC PowerProtect DD9400 - Configuring Additional System Parameters

DNS Servers
E
nter the DNS Server list (zero, one, two or three IP addresses):
192.168.10.1
9. A summary of the network settings is displayed. You can accept the settings (Save), reject the settings and exit to the CLI
(Cancel), or return to the beginning of the current section and change the settings (Retry). Entering Retry displays your
previous responses for each prompt. Press Return to accept the displayed value or enter a new one.
Pending Network Settings
H
ostname dd9400.example.com
Domain name example.com
Default Gateway 192.168.10.1
DNS Server List 192.168.10.1
----- ------- ------- ---- ------------------------------------
--------------- ---- ------------------
ethMa yes running no 192.168.10.1
255.255.252.0 n/a
fe80::3680:dff:fe42:2660** /64
2620:0:170:2532:3680:dff:fe42:2660** /64
ethMb no down ipv4 n/a n/
a n/a
ethMc no down ipv4 n/a n/
a n/a
ethMd no down ipv4 n/a n/
a n/a
eth5a no down no n/a n/
a n/a
eth5b no down no n/a n/
a n/a
eth6a yes running no (not specified) (not
specified) n/a
fe80::f6e9:d4ff:fe7f:eea0 /64
eth6b yes running no (not specified) (not
specified) n/a
fe80::f6e9:d4ff:fe7f:eea1 /64
eth6c no down no n/a n/
a n/a
eth6d no down no n/a n/
a n/a
eth8a no down no n/a n/
a n/a
eth8b no down no n/a n/
a n/a
eth8c no down no n/a n/
a n/a
eth8d no down no n/a n/
a n/a
----- ------- ------- ---- ------------------------------------
--------------- ---- ------------------
Do you want to save these settings (Save|Cancel|Retry):
Configuring additional system parameters
About this task
Most installations would benefit from the configuration of a few additional system parameters, provided in this section for
convenience.
NOTE:
You can also use the Data Domain (DD) System Manager GUI interface to configure the system parameters. Open a
web browser, and enter your Data Domain system’s IP address in the browser’s address text box. Log in when the DD
System Manager login screen displays. Use the DD System Manager online help for more information.
Steps
1
. To set up the mail server, enter:
# config set mailserver mail.datadomain.com
The Mail (SMTP) server is: mail.datadomain.com
2. To set up the system location, enter:
70 Configure System for Use