License page
T
he License page displays all installed licenses. Click Yes to add, modify, or delete a license, or click No to skip license
installation.
License Configuration
The Licenses Configuration section enables you add, modify, or delete licenses from a license file. DD OS 6.0 and later
supports licensing via the Electronic License Management System (ELMS), which enables you to include multiple features in a
single license file upload.
When using the Configuration Wizard on a system with no licenses configured, select the license type from the drop-down, and
click the ... button. Browse to the directory where the license file resides, and select it for upload to the system.
Table 18. License Configuration page values
Item Description
Add Licenses Select this option to add licenses from a license file.
Replace Licenses If licenses are already configured the A
dd Licenses selection changes to Replace
Licenses. Select this option to replace the licenses already added.
Delete Licenses Select this option to delete licenses already configured on the system.
Network
The Network section enables you to configure the network settings. Click Yes to configure the network settings, or click No to
skip network configuration.
Network General page
The General page enables you to configure network settings that define how the system participates in an IP network.
To configure these network settings outside of the configuration wizard, select Hardware > Ethernet.
Table 19. General page settings
Item Description
Obtain Settings using DHCP Select this option to specify that the system collect network settings from a
D
ynamic Host Control Protocol (DHCP) server. When you configure the network
interfaces, at least one of the interfaces should be configured to use DHCP.
Manually Configure Select this option to use the network settings defined in the Settings area of this
page.
Host Name Specifies the network hostname for this system.
NOTE: If you choose to obtain the network settings through DHCP, you can
manually configure the hostname at Hardware > Ethernet > Settings or with
the net set hostname command. You must manually configure the host
name when using DHCP over IPv6.
Domain Name Specifies the network domain to which this system belongs.
Default IPv4 Gateway Specifies the IPv4 address of the static default gateway to which the system will
f
orward network requests when there is no route entry for the destination system.
Default IPv6 Gateway Specifies the IPv6 address of the static default gateway to which the system will
forward network requests when there is no route entry for the destination system.
72 Configure System for Use
To Next Page
Loading...
