Dell EMC PowerProtect DD9900 - Install the System in the Rails; Installing a Custom OEM Bezel Faceplate

Figure 13 Install the system in the rails
1. Server-lock latch (2)
2. Inner slide rail (2)
3. System
4. Standoff on the system
5. Slide-release lock latch (2)
6. J-slot on the rail
7. Screw (2)
8. Slam latch (2)
Installing a custom OEM bezel faceplate
Procedure
1. Align the custom faceplate with the OEM bezel.
2. Using a Phillips #1 screw driver, secure the opposite ends of the faceplate to the corners of
the bezel.
3. Secure the faceplate to the bezel with the remaining screws.
Install the System in the Rack
Dell EMC PowerProtect DD9900 System Installation Guide 27