Table 3 Pins for third-party racks
Rail Pins from kit Part Number and Description Suggested Use
036-028-018
Custom screw, M4 x 10MM
(Quantity: 4 per kit)
Used for any third-party rack.
Can be used in racks with
threaded holes.
036-028-016
3.8MM Alignment Pin
(Quantity: 8 per kit)
Used in racks that have M5,
#10, or #12 threaded holes.
036-028-017
4.8MM Alignment Pin
(Quantity: 8 per kit)
Used in racks that have M6
threaded holes.
4. Install the right rail to the rack rear channel. You can adjust the rails later, if necessary. The
following figure shows the installation details.
Refer to Figure 22 on page 37 while performing the tasks in this step.
Install the Disk Shelves in the Rack
Dell EMC PowerProtect DD9900 System Installation Guide 35
To Next Page
Loading...
