Figure 36 Spring clips—push up to release tray
Figure 37 Opening the cable chain lids
4. Unclip and open all lids on the cable chains.
Figure 38
Cable positioning in cable chains
5. Refer to the application guide for the shelf you are installing. Using the 1-inch graduations
on the back edge of the tray, route the cables through the cable chains to their suggested
lengths, keeping in mind the correct pig-tail lengths. The two outside cable runs connect to
Install the Disk Shelves in the Rack
Dell EMC PowerProtect DD9900 System Installation Guide 47
To Next Page
Loading...
