Dell EMC PowerProtect DD9900 - Attaching Cable Chains to Tray; Installing the Chassis Bracket into the Shelf; Inch Graduation Label

the rack, while the two inside cable runs connect to the shelf. Once the cables are installed,
close the lids, making sure that they are snapped shut.
Figure 39 1-Inch graduation label
CL5522
6. Align the lids of the cable chains so the lids are facing up and the hinges are all facing each
other. Arrange the two cable chains so that they form a "U" shape.
Figure 40 Attaching cable chains to tray
7. Attach the Cable Chains to the tray, by attaching the clips onto the tabs on the rear of the
tray.
Figure 41
Installing the chassis bracket into the shelf
CL5500
8. Snap the chassis bracket clips into the brackets on the side of the chassis.
Install the Disk Shelves in the Rack
48 Dell EMC PowerProtect DD9900 System Installation Guide