Figure 52 Nutbar installation (Left nutbar shown)
Note: The nutbars are not interchangeable. There is a distinct nutbar for the left and right side.
Use part numbers for identification.
Procedure
1. At the front of the rack, align and install the left nutbar (051-000-357) directly above the
rail assembly.
2. Secure the nutbar with two M5 securing screws, one above the top alignment pin and one
below the lower alignment pin.
3. Repeat the previous steps for the right nutbar (051-000-356).
Install an FS25 shelf into the rack
If installing an FS25 is required, complete the following steps to install the FS25 SSD shelf.
Install the Disk Shelves in the Rack
58 Dell EMC PowerProtect DD9900 System Installation Guide
To Next Page
Loading...
