Figure 60 DD9900 with DS60 shelves
Connecting the HA interconnect
Procedure
1. Connect a 10G Base-T cable from port 2 of the network daughter card on the primary node
to port 2 of the network daughter card on the standby node.
2. Connect a 10G Base-T cable from port 3 of the network daughter card on the primary node
to port 3 of the network daughter card on the standby node.
3. Connect a 10G Base-T cable from port 4 of the network daughter card on the primary node
to port 4 of the network daughter card on the standby node.
Connect Cables and Power On
66 Dell EMC PowerProtect DD9900 System Installation Guide
To Next Page
Loading...
