Dell EMC PowerProtect DD9900 - Configuring Additional System Parameters

a n/a
ethMc no down ipv4 n/a n/
a n/a
ethMd no down ipv4 n/a n/
a n/a
eth5a no down no n/a n/
a n/a
eth5b no down no n/a n/
a n/a
eth6a yes running no (not specified) (not
specified) n/a
fe80::f6e9:d4ff:fe7f:eea0 /64
eth6b yes running no (not specified) (not
specified) n/a
fe80::f6e9:d4ff:fe7f:eea1 /64
eth6c no down no n/a n/
a n/a
eth6d no down no n/a n/
a n/a
eth8a no down no n/a n/
a n/a
eth8b no down no n/a n/
a n/a
eth8c no down no n/a n/
a n/a
eth8d no down no n/a n/
a n/a
----- ------- ------- ---- ------------------------------------
--------------- ---- ------------------
Do you want to save these settings (Save|Cancel|Retry):
Configuring additional system parameters
About this task
Most installations would benefit from the configuration of a few additional system parameters,
provided in this section for convenience.
Note:
You can also use the Data Domain (DD) System Manager GUI interface to configure the
system parameters. Open a web browser, and enter your Data Domain system’s IP address in
the browser’s address text box. Log in when the DD System Manager login screen displays.
Use the DD System Manager online help for more information.
Procedure
1. To set up the mail server, enter:
# config set mailserver mail.datadomain.com
The Mail (SMTP) server is: mail.datadomain.com
2. To set up the system location, enter:
# config set location "Dallas Regional Data Center Lab,
5000 Apple Drive Suite #130, Dallas, Tx"
The System Location is: Dallas Regional Data Center Lab,
5000 Apple Drive Suite #130, Dallas, Tx
3. To add one or more time servers, enter:
# ntp add timeserver 192.168.101.1
Remote Time Servers: 192.168.10.1
4. To enable the NTP daemon, enter:
# ntp enable
NTP enabled.
5. To change the system time zone, enter:
# config set timezone US/Central
The Timezone name is: US/Central
*** You made a change to the timezone setting. To fully effect this
Configure System for Use
78 Dell EMC PowerProtect DD9900 System Installation Guide