Figure 66 iDRAC power options
Configure HA
Before you begin
l
The HA interconnect between both nodes is connected.
Note:
Connecting the HA interconnect on page 66 describes how to cable the HA
interconnect.
l
The data connections on both nodes are connected.
About this task
Configure the two nodes as an HA pair.
Note:
Configuring an HA pair sets the system password on the standby node to match the
system password on the active node, however, that synchronization is not set until the HA
configuration is complete. If the HA configuration fails, or if there is a need to access either
node before the HA configuration is complete, use the serial number of each node as the
password.
Procedure
1. Verify the certificate subject name on the primary node.
Run the following command:
Configure System for Use
92 Dell EMC PowerProtect DD9900 System Installation Guide
To Next Page
Loading...
